Route Delete Command; Route Show Command - ZyXEL Communications AAM1212 User Manual

AAM1212 User's Guide
or
ras> ip route set default <gateway ip> <metric>
where
<dst ip>
[/netmask]
<gateway ip>
[metric]
<name>
default
This command defines a new, static IP forwarding route or edits an existing one.

29.4.4 Route Delete Command

Syntax:
ras> ip route delete <dst ip>[/netmask]
where
<dst ip>
[/netmask]
This command removes a static, IP forwarding route.

29.4.5 Route Show Command

Syntax:
ras> ip route show
This command displays the AAM's routing table.
An example is shown next.
246
= The destination IP address of packets that this static route is to route.
= The destination subnet mask of packets that this static route is to route.
= The IP address of the gateway that you want to send the packets
through.
= The metric (hop count) of this static route.
= A name to identify this static route. Up to 31 ASCII characters. Spaces
and tabs are not allowed.
= Use this to configure the AAM's default route.
= The destination IP address of packets to which this static route applies.
= The destination subnet mask of packets to which this static route
applies.
Chapter 29 IP Commands