Route Delete Command; Route Show Command; Arp Show Command; Figure 207 Route Show Command Example - ZyXEL Communications IES-1248-71 User Manual

[/netmask]
<gateway ip>
[metric]
<name>
default
This command defines a new, static IP forwarding route or edits an existing one.

52.3.4 Route Delete Command

Syntax:
ras> ip route delete <dst ip>[/netmask]
where
<dst ip>
[/netmask]
This command removes a static, IP forwarding route.

52.3.5 Route Show Command

Syntax:
ras> ip route show
This command displays the IES-1248's routing table.
An example is shown next.

Figure 207 Route Show Command Example

ras> ip route show
index dest
----- --------------- --------------- ------ ------------------------------
-
1 192.168.1.0/24
2 default

52.3.6 ARP Show Command

Syntax:
ras> ip arp show
This command displays the IES-1248's IP Address Resolution Protocol table. This is the list of
IP addresses and matching MAC addresses that the IES-1248 has resolved.
IES-1248-71/73 User's Guide
The destination subnet mask of packets that this static route is to
=
route.
The IP address of the gateway that you want to send the packets
=
through.
The metric (hop count) of this static route.
=
A name to identify this static route. Up to 31 ASCII characters.
=
Spaces and tabs are not allowed.
Use this to configure the IES-1248's default route.
=
The destination IP address of packets to which this static route
=
applies.
The destination subnet mask of packets to which this static route
=
applies.
gateway metric name
192.168.1.1
192.168.1.254
Chapter 52 IP Commands
1
1
355