Example For Configuring An Ipv6 Over Ipv4 Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service

12.5.1 Example for Configuring an IPv6 over IPv4 Tunnel

This section provides a configuration example of IPv6 over IPv4 tunnel.
Networking Requirements
Figure 12-2 Networking diagram for configuring the IPv4 over IPv6 tunnel
SwitchA
As shown in
Switch A and Switch E. The border devices on the IPv6 network Switch B and Switch D support
IPv4/IPv6 stack. An IPv4 over IPv6 tunnel needs to be set up between Switch B and Switch D
to enable the interconnection of the two IPv4 networks that are isolated physically.
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data.
l
l
l
Issue 01 (2012-03-15)
GE1/0/0
IPv4 VLANIF 100
10.1.2.1/30
GE 1/0/0
VLANIF 100
10.1.2.2/30
SwitchB
Figure 12-2, two IPv4 networks are connected to an IPv6 network through
Set an IPv4 over IPv6 tunnel on the border devices at both ends of the IPv6 network.
Configure the route that is forwarded through the tunnel interface.
Routing protocols used on the IPv6 network and IPv4 network
Source and destination IPv6 addresses at both ends of the tunnel
IPv4 address of the tunnel interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 IPv4 over IPv6 Tunnel Configuration
IPv6
GE1/0/0
VLANIF 200
SwitchC
2001::2/64
GE 2/0/0
VLANIF 200
2001::1/64
GE 2/0/0
VLANIF 100
2002::1/64
GE 1/0/0
VLANIF 100
2002::2/64
SwitchD
GE2/0/0
VLANIF 200
10.1.3.1/30
GE1/0/0
VLANIF 200
10.1.3.2/30
SwitchE
IPv4
229