Huawei S9300 Configuration Manual page 223

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port hybrid pvid vlan 100
[Quidway-GigabitEthernet1/0/1] port hybrid untagged vlan 100
[Quidway-GigabitEthernet1/0/1] quit
[Quidway] interface gigabitethernet 1/0/2
[Quidway-GigabitEthernet1/0/2] port hybrid pvid vlan 200
[Quidway-GigabitEthernet1/0/2] port hybrid untagged vlan 200
[Quidway-GigabitEthernet1/0/2] quit
[Quidway] interface vlanif 100
[Quidway-Vlanif100] ipv6 enable
[Quidway-Vlanif100] ipv6 address 3001::1/64
[Quidway-Vlanif100] quit
[Quidway] interface vlanif 200
[Quidway-Vlanif200] ip address 2.1.1.1 255.0.0.0
[Quidway-Vlanif200] quit
# Configure an ISATAP tunnel.
[Quidway] interface tunnel 1/0/2
[Quidway-Tunnel0/0/2] eth-trunk 1
[Quidway-Tunnel1/0/2] tunnel-protocol ipv6-ipv4 isatap
[Quidway-Tunnel1/0/2] ipv6 enable
[Quidway-Tunnel1/0/2] ipv6 address 2001::/64 eui-64
[Quidway-Tunnel1/0/2] source vlanif 200
[Quidway-Tunnel1/0/2] undo ipv6 nd ra halt
[Quidway-Tunnel1/0/2] quit
Step 2 Configure the ISATAP host.
# Configure a static route to the border device. (The pseudo interface number of the host is 2.
You can run the ipv6 if command to view the interface corresponding to the automatic tunneling
pseudo interface.)
C:\> netsh interface ipv6 isatap set router 2.1.1.1
Step 3 Configure the IPv6 host.
# Configure a static route on the IPv6 host to the border device, so hosts in different networks
can communicate through the ISATAP tunnel.
C:\> netsh interface ipv6 set route 2001::/64 3001::1
Step 4 Verify the configuration.
Check the status of the Tunnel 1/0/2 on the ISATAP device and find it is Up.
[Quidway] display ipv6 interface tunnel 1/0/2
Tunnel1/0/2 current state : UP
IPv6 protocol current state : UP
IPv6 is enabled, link-local address is FE80::5EFE:201:101 [TENTATIVE]
Global unicast address(es):
Joined group address(es):
MTU is 1500 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisement max interval 600 seconds, min interval 200 seconds
ND router advertisements live for 1800 seconds
ND router advertisements hop-limit 10
Hosts use stateless autoconfig for addresses
Issue 01 (2012-03-15)
NOTE
The ISATAP host needs to run IPv6 and needs to be enabled with the IPv6 function.
2001::5EFE:201:101, subnet is 2001::/64 [TENTATIVE]
FF02::1:FF01:101
FF02::2
FF02::1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
212