Configuring Routes In The Tunnel; Checking The Configuration; Configuring 6Pe; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The device is allowed to advertise routes.
----End

11.4.6 Configuring Routes in the Tunnel

Packets can be normally forwarded only when routes exist on both the source device and
destination device of the tunnel.
Context
Configuring routes in the tunnel comprises configuring static routes and dynamic routes.
l

11.4.7 Checking the Configuration

Prerequisites
All configurations of the IPv6 over IPv4 tunnel are complete.
Procedure
Step 1 Run the display ipv6 interface tunnel interface-number command to view the IPv6 attribute
of the tunnel interface.
----End

11.5 Configuring 6PE

By performing this configuration task, you can interconnect IPv6 networks through the existing
MPLS network.

11.5.1 Establishing the Configuration Task

This section describes the applicable environment, pre-configuration tasks, data preparation, and
configuration procedure for configuring 6PE.
Applicable Environment
To interconnect IPv6 networks over the existing MPLS network, 6PE must be configured on the
PE devices.
Pre-configuration Tasks
Before configuring 6PE, complete the following tasks:
Issue 01 (2012-03-15)
When configuring a static route, you need to run the ipv6 route-static dest-ipv6-address
prefix-length { interface-type interface-number nexthop-ipv6-address | nexthop-ipv6-
address } command to configure a route destined for the destination address (the destination
address specified before the packet encapsulation, rather than the destination address of the
tunnel). In addition, you need to set the next hop address to the address of the interface on
the remote end of the tunnel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
196