Configuration Examples; Example For Setting An Ipv6 Address For An Interface - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service

9.7 Configuration Examples

This section provides a configuration example of IPv6 addresses.

9.7.1 Example for Setting an IPv6 Address for an Interface

This section provides a configuration example of IPv6 address for an interface.
Networking Requirements
As shown in
of Switch A and Switch B correspond to their VLANIF 100 interfaces. You need to set IPv6
global unicast addresses for the VLANIF 100 interfaces and check the Layer 3 interconnection
between them.
The IPv6 global unicast addresses for the interfaces are 3001::1/64 and 3001::2/64.
Figure 9-1 Networking diagram for setting IPv6 addresses
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data.
l
Procedure
Step 1 Enable the IPv6 forwarding capability on the Switch.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] ipv6
# Configure Switch B.
Issue 01 (2012-03-15)
Figure 9-1, two Switches are connected through GE 1/0/1. The GE 1/0/1 interfaces
SwitchA
GE 1/0/1
VLANIF 100
3001::1/64
Enable the IPv6 forwarding capability on the Switch.
Set IPv6 global unicast addresses for the interfaces.
Global unicast address of an interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE 1/0/1
VLANIF 100
3001::2/64
9 Basic Configurations of IPv6
168