Example For Configuring An Isatap Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
l

11.7.3 Example for Configuring an ISATAP Tunnel

This section provides a configuration example of ISATAP tunnel.
Network Requirements
As shown in
needs to access the IPv6 network through a border device. Both the IPv6 host and the border
device support ISATAP. Then you need to set up an ISATAP tunnel between the IPv6 host and
the border device.
Issue 01 (2012-03-15)
GigabitEthernet1/0/3
eth-trunk 1
#
interface Tunnel1/0/1
eth-trunk 1
ipv6 enable
ipv6 address 2002:201:101:1::1/64
tunnel-protocol ipv6-ipv4 6to4
source vlanif100
#
ipv6 route-static 2002:: 16 Tunnel 1/0/1
#
return
Configuration file of Switch B
#
sysname SwitchB
#
ipv6
#
vlan batch 100 200
#
interface Vlanif100
ip address 2.1.1.2 255.0.0.0
#
interface Vlanif200
ipv6 enable
ipv6 address 2002:201:102:1::1/64
#
interface Eth-Trunk1
service type tunnel
#
interface GigabitEthernet1/0/1
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet1/0/2
port hybrid pvid vlan 200
port hybrid untagged vlan 200
#
interface GigabitEthernet1/0/3
eth-trunk 1
#
interface Tunnel1/0/1
ipv6 enable
ipv6 address 2002:201:102:1::1/64
tunnel-protocol ipv6-ipv4 6to4
source vlanif100
#
ipv6 route-static 2002:: 16 Tunnel 1/0/1
#
return
Figure 11-8, an IPv6 host in the IPv4 network running the Windows XP system
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
210