Configuring Ipv4/Ipv6 Dual Protocol Stacks - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
l
l
l
l
Data Preparation
To configure 6PE, you need the following data.
No.
1
2
3
4
5

11.5.2 Configuring IPv4/IPv6 Dual Protocol Stacks

You need to enable the IPv4/IPv6 dual stack on the border device of the IPv4 and IPv6 networks.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ipv6
The IPv6 packet forwarding is enabled.
Step 3 Run:
interface interface-type interface-number
The interface view of the IPv4 network is displayed.
Step 4 Run:
ip address ip-address { mask | mask-length }
The interface is configured with an IPv4 address.
Step 5 Run:
quit
Return to the system view.
Issue 01 (2012-03-15)
Configuring the physical features of interfaces and ensuring that the status of the physical
layer of the interface is Up
Configuring the link layer protocols on interface and ensuring that the status of the link
layer protocol on the interface is Up
Configuring routes from 6PE to CE
Configuring routes to the backbone network
Data
Interface number and IPv6 address of the 6PE's interface connected with CE devices
Interface number and IPv4 address of the 6PE's interface
Interface number and IPv4 address of the loopback interface to be created
LSP triggering policy
IPv4 address of the peer of the 6PE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
197