Huawei S9300 Configuration Manual page 222

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Figure 11-8 Networking diagram of the ISATAP tunnel
IPv6 host
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure the ISATAP device.
# Enabling the service loopback function on an Eth-Trunk interface.
The interface must be idle. That is, the interface does not transmit services.
<Quidway> system-view
[Quidway] interface eth-trunk 1
[Quidway-Eth-Trunk1] service type tunnel
[Quidway-Eth-Trunk1] quit
[Quidway] interface gigabitethernet 1/0/3
[Quidway-GigabitEthernet1/0/3] eth-trunk 1
[Quidway-GigabitEthernet1/0/3] quit
# Enable IPv4/IPv6 dual protocol stacks and configure an IP address for each interface.
<Quidway> system-view
[Quidway] ipv6
[Quidway] vlan batch 100 200
Issue 01 (2012-03-15)
IPv6
network
GE1/0/1
3001::2
VLANIF 100
3001::1/64
Enabling the service loopback function on an Eth-Trunk interface.
Configure IPv4/IPv6 dual protocol stacks.
Configure an ISATAP tunnel.
Configure static routes from the IPv6 host to the ISATAP host.
IPv4 or IPv6 addresses of interfaces
Source interface of the tunnel
VLAN that the physical interface of the Switch belongs to
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ISATAP
IPv4
network
Switch
GE1/0/2
FE80::5EFE:0201:0102
VLANIF 200
2.1.1.1/8
2001::5EFE:0201:0102
11 IPv6 over IPv4 Tunnel Configuration
ISATAP host
2.1.1.2
211