S9700 Core Routing Switch
Configuration Guide - SPU
5.7.7 Checking the Configuration
Prerequisites
The NetStream configuration is complete.
Procedure
Step 1 Run the display ip netstream all and display ipv6 netstream all commands to view the
NetStream configuration.
----End
5.8 Example for Configuring NetStream
This section provides several configuration examples of NetStream.
5.8.1 Example for Configuring NetStream of IPv4 Original Traffic
Networking Requirements
As shown in
through Switch A. The NetStream function is enabled on Switch B. The carrier collects statistics
about the packets sent and received by GE 1/0/0 of Switch B. The traffic statistics are used as
the basis for network accounting.
Figure 5-2 Networking diagram for NetStream configuration
Configuration Roadmap
The configuration roadmap is as follows:
1.
Issue 01 (2012-03-15)
Figure
5-2, the enterprise network is connected to the access Switch B of the carrier
User
GE1/0/0
Network
VLANIF 100
10.1.1.1/24
SwitchA
Set IP addresses for interfaces on Switch A and Switch B.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE2/0/0
VLANIF 200
10.2.1.1/24
NSC&NDA
10.2.1.2/24
GE1/0/0
VLANIF 100
10.1.1.2/24
XGE4/0/0
XGE4/0/1
VLANIF101
22.22.22.2/24
5 NetStream Configuration
SwitchB
XGE0/0/1
VLAN101
XGE0/0/2.2
22.22.22.1/24
167