Checking The Configuration; Maintaining Ipv6 Over Ipv4 Tunnels; Monitoring The Running Status Of Ipv6 Over Ipv4 Tunnel; Debugging Ipv6 Over Ipv4 Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Label routing capacity is enabled for 6PE.
----End

11.5.5 Checking the Configuration

Prerequisites
All configurations are complete.
Procedure
Step 1 Run the display mpls lsp command to view information about LSP.
Step 2 Run the display bgp ipv6 routing-table command to view information about IPv6 BGP routes.
----End

11.6 Maintaining IPv6 over IPv4 Tunnels

This section describes how to maintain an IPv6 over IPv4 tunnel, including how to monitor an
IPv6 over IPv4 tunnel.

11.6.1 Monitoring the Running Status of IPv6 over IPv4 Tunnel

This section describes how to monitor an IPv6 over IPv4 tunnel.
Context
In routine maintenance, you can run the following command in any view to check the operation
of IPv6 over IPv4 tunnel.
Procedure
Step 1 Run the display ipv6 interface tunnel { interface-number } command in any view to check the
operation status of the tunnel interface.
----End

11.6.2 Debugging IPv6 over IPv4 Tunnel

This section describes how to debug an IPv6 over IPv4 tunnel.
Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
Issue 01 (2012-03-15)
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
200