Configuration Examples; Example For Configuring An Ipv6 Over Ipv4 Tunnel Manually - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
If an operation fault occurs on the IPv6 tunnel, run the following debugging commands in the
user view to debug the IPv6 tunnel. View information about debugging, locate the fault, and
analyze the cause.
For the procedure of displaying the debugging information, refer to the chapter "Information
Center Configuration" in the S9300&S9300E Terabit Routing Switch Configuration Guide -
System Management.
Procedure
Step 1 Run the debugging tunnel { all | control | error | keepalive | packet | timer } [ interface
tunnel interface-number ] command in the user view to debug tunnel information.
----End

11.7 Configuration Examples

This section provides configuration examples of IPv6 over IPv4 tunnel.

11.7.1 Example for Configuring an IPv6 over IPv4 Tunnel Manually

This section provides a configuration example of manual IPv6 over IPv4 tunnel.
Networking Requirements
As shown in
network respectively through Switch A and Switch C. To enable the communication between
two IPv6 networks, manually configure an IPv6 over IPv4 tunnel between Switch A and
Switch C.
Figure 11-6 Networking diagram for configuring the IPv6 over IPv4 tunnel manually
192.168.50.2/24
Configuration Roadmap
The configuration roadmap is as follows:
Issue 01 (2012-03-15)
Figure 11-6, two IPv6 networks are connected to Switch B on the IPv4 backbone
network
GE 1/0/1
VLANIF 100
192.168.50.1/24
GE 1/0/1
VLANIF 100
SwitchB
Dual
IPv6
stack
SwitchA
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IPv4
GE 1/0/2
VLANIF 200
192.168.51.1/24
GE 1/0/1
VLANIF 200
192.168.51.2/24
Dual
IPv6
stack
SwitchC
11 IPv6 over IPv4 Tunnel Configuration
201