Optional) Configuring The Netbios Service Of The Vlanif Interface Address Pool - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The VLANIF interface view is displayed.
Step 3 Run:
dhcp server domain-name domain-name
The DNS domain name is configured for the DHCP client.
Step 4 Run:
dhcp server dns-list ip-address &<1-8>
The DNS server address is configured for the DHCP client.
To load balance the traffic and improve the reliability of the network, configure multiple DNS
servers. Each address pool can be configured with a maximum of eight DNS servers.
----End
3.4.4 (Optional) Configuring the NetBIOS Service of the VLANIF
Interface Address Pool
DHCP clients running on the Microsoft Windows operating system use the Network Basic Input
Output System (NetBIOS) protocol for communication. The NetBIOS server translates host
names to IP addresses for the clients.
Context
Perform the following steps on the DHCP server.
When a DHCP client uses the NetBIOS protocol for communication, the host name must be
mapped to an IP address. Based on the modes of obtaining mapping, NetBIOS nodes are
classified into the following types:
l
l
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
dhcp server nbns-list ip-address &<1-8>
The NetBIOS server address is configured for the DHCP client.
Issue 01 (2012-03-15)
b-node: indicates a node in broadcast mode. This node obtains the mappings in broadcast
mode.
p-node: indicates a node in peer-to-peer mode. This node obtains the mappings by
communicating with the NetBIOS server.
m-node: indicates a node in mixed mode, that is, the p-type node with some broadcast
features.
h-node: indicates a node in hybrid mode, that is, a b-type node enabled with the end-to-end
communication mechanism.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 DHCP Configuration
61