Configure An Ip Addresses For The Interface; Enabling Proxy Arp Within A Vlan; Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service

2.6.2 Configure an IP Addresses for the Interface

The IP address assigned to an interface needs to be in the same network segment with the IP
addresses of the users of the VLANs associated to this interface.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Intra-VLAN proxy ARP can be enabled on only the VLANIF interface of the
S9300&S9300E.
Step 3 Run:
ip address ip-address { mask | mask-length }
The interface is configured with an IP address.
The IP address configured for the interface must be in the same network segment with that of
hosts in the VLAN associated with this interface.
----End

2.6.3 Enabling Proxy ARP Within a VLAN

To interconnect isolated users on a VLAN, you need to enable intra-VLAN proxy ARP on the
interface associated to the VLAN.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
arp-proxy inner-sub-vlan-proxy enable
Proxy ARP within a VLAN is enabled.
----End

2.6.4 Checking the Configuration

You can view the configuration of intra-VLAN proxy ARP.
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 ARP Configuration
25