Huawei S9300 Configuration Manual page 109

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
1.
2.
3.
4.
5.
6.
7.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Context
Procedure
Step 1 Enable DHCP globally.
<Quidway> system-view
[Quidway] dhcp enable
Step 2 Enable the IP session function on sub-interfaces.
# Enable the IP session function on GE1/0/1.100.
[Quidway] interface gigabitethernet 1/0/1.100
[Quidway-GigabitEthernet1/0/1.100] ip-session enable
[Quidway-GigabitEthernet1/0/1.100] quit
# Enable the IP session function on GE1/0/2.100.
[Quidway] interface gigabitethernet 1/0/2.100
[Quidway-GigabitEthernet1/0/2.100] ip-session enable
[Quidway-GigabitEthernet1/0/2.100] quit
Step 3 Bind user authentication domains to sub-interfaces.
# Bind the user authentication domain stb-a to GE 1/0/1.100.
[Quidway] aaa
[Quidway-aaa] domain stb-a
[Quidway-aaa-domain-stb-a] quit
[Quidway-aaa] quit
Issue 01 (2012-03-15)
Enable global DHCP.
Enable the IP session function.
Bind the user authentication domain to a sub-interface.
Set IP session-related parameters for the sub-interface.
Configure a DHCP server group.
Configure an egress gateway.
Configure a static route.
Physical parameters on the sub-interface
VLAN ID of the interface
Type of the NAS interface
ARP detection parameter
Name of the DHCP server group: dhcp-group
Gateway address: 20.20.20.20
IP address of the DHCP server: 10.10.10.10
NOTE
Only IP session-related configurations are involved in this example. The AAA configurations, RADIUS
configurations, multicast-related configurations, and router-related configurations are not described in this
example.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 IP Session Configuration
98