Example For Configuring 6Pe - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
ipv6 enable
ipv6 address 3001::1/64
#
interface Vlanif200
ip address 2.1.1.1 255.0.0.0
#
interface Eth-Trunk1
service-type tunnel
#
interface GigabitEthernet1/0/3
eth-trunk 1
#
interface Tunnel1/0/2
ipv6 enable
ipv6 address 2001::/64 eui-64
undo ipv6 nd ra halt
tunnel-protocol ipv6-ipv4 isatap
source Vlanif200
#
interface GigabitEthernet1/0/1
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet1/0/2
port hybrid pvid vlan 200
port hybrid untagged vlan 200
#
return

11.7.4 Example for Configuring 6PE

This section provides a configuration example of 6PE.
Networking Requirements
As shown in
IPv6 protocol. Between PE devices is the IPv4/MPLS network of carriers. IBGP connections of
IPv4 need to be set up between PEs. IGP adopts the OSPF routing protocol. The CE device is
located on an IPv6 network. The PE device and CE device exchange routing information in static
routing mode through the IPv6 address.
Use the 6PE feature to connect IPv6 networks of users through the IPv4/MPLS network of
carriers.
Issue 01 (2012-03-15)
NOTE
To run MPLS-related commands, you need to purchase a license.
Figure 11-9, PE1 and PE2 support the 6PE feature, and CE1 and CE2 support the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
214