Huawei S9300 Configuration Manual page 213

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data.
l
l
Procedure
Step 1 Configure Switch A.
# Enabling the service loopback function on an Eth-Trunk interface.
The interface must be idle. That is, the interface does not transmit services.
<Quidway> system-view
[Quidway] interface eth-trunk 1
[Quidway-Eth-Trunk1] service type tunnel
[Quidway-Eth-Trunk1] quit
[Quidway] interface gigabitethernet 1/0/3
[Quidway-GigabitEthernet1/0/3] eth-trunk 1
[Quidway-GigabitEthernet1/0/3] quit
# Assign IP addresses to interfaces.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] ipv6
[SwitchA] vlan 100
[SwitchA-vlan100] quit
[SwitchA] interface gigabitethernet1/0/1
[SwitchA-GigabitEthernet1/0/1] port hybrid pvid vlan 100
[SwitchA-GigabitEthernet1/0/1] port hybrid untagged vlan 100
[SwitchA-GigabitEthernet1/0/1] quit
[SwitchA] interface vlanif 100
[SwitchA-Vlanif100] ip address 192.168.50.2 255.255.255.0
[SwitchA-Vlanif100] quit
# Set the tunnel protocol to IPv6-IPv4.
[SwitchA] interface tunnel 1/0/1
[SwitchA-Tunnel1/0/1] tunnel-protocol ipv6-ipv4
# Bind the tunnel interface to the Eth-Trunk.
[SwitchA-Tunnel1/0/1] eth-trunk 1
# Set IPv6 address and destination address for the tunnel interface.
[SwitchA-Tunnel1/0/1] ipv6 enable
[SwitchA-Tunnel1/0/1] ipv6 address 3001::1/64
Issue 01 (2012-03-15)
Enabling the service loopback function on an Eth-Trunk interface.
Set the IP address for the VLANIF interface mapping with the physical interface.
Configure IPv6 addresses, source interface, and destination addresses for the tunnel
interfaces.
Set the tunnel protocol to IPv6-IPv4.
IP addresses of interfaces
IPv6 address, source address, and destination address of the tunnel
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
202