Configuring An Interface To Use Global Address Pool - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
l
l
l
Data Preparation
Before configuring the DHCP server based on the global address pool, you need the following
data.
No.
1
2
3
4
5

3.3.2 Configuring an Interface to Use Global Address Pool

When a DHCP server receives a DHCP packet from a client, the server can allocate an IP address
to the client from the global address pool.
Context
Perform the following steps on the DHCP server.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
dhcp enable
The DHCP function is enabled.
Step 3 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 4 Run:
ip address ip address { mask | mask-length}
Issue 01 (2012-03-15)
(Optional) Configuring the NetBIOS server
Configuring routes from the S9300&S9300E to the DNS server and the NetBIOS server
(The routes are required only when the servers are configured.)
(Optional) Configuring the customized DHCP option
Data
Address pool name, IP address range, IP address lease, IP addresses not to be allocated
in the IP address pool (optional), and IP address and MAC address that need to be
statically bound (optional)
Egress gateway of the DHCP clients
(Optional) IP address of the DNS server and domain name of the DHCP clients
(Optional) IP address of the NetBIOS server and NetBIOS node type of the DHCP
clients
(Optional) Code of the customized DHCP option and corresponding ASCII character
string, hexadecimal numeral, or IP address
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 DHCP Configuration
50