Configuring Other Information To Be Advertised - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
ipv6 enable
You can enable the IPv6 capability.
Step 4 Run:
ipv6 nd ra prefix { ipv6-address ipv6-prefix-length | ipv6-prefix/ipv6-prefix-
length } valid-lifetime preferred-lifetime [ no-autoconfig ] [ off-link ]
The prefix of RA messages is configured.
----End

9.4.7 Configuring Other Information to Be Advertised

A router advertisement message carries information such as the maximum number of hops,
prefix option, neighbor hold time, and keepalive time.
Context
Duplicate Address Detect (DAD) is a process of IPv6 automatic address configuration. You can
configure the number of DAD messages which are sent continuously.
Set the interval of sending Neighbor Solicitation (NS) messages on the device. By default, NS
re-transmitting time interval is 1000ms.
Neighbor Unreachability Detection (NUD) checks the reachability of neighbors. By default,
NUD value is 30000ms.
The MTU of the interface determines whether to fragment IP packets on the interface. Default
MTUs vary with interface types. The MTU on an GigabitEthernet interface defaults to be 1500
bytes.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ipv6 nd hop-limit limit
ND hop limit is configured.
The value of limit ranges from 1 to 255. By default, it is 64.
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Basic Configurations of IPv6
160