Monitoring The Operation Status Of Ipv4 Over Ipv6 Tunnel; Debugging Ipv4 Over Ipv6 Tunnel; Configuration Examples - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service

12.4.1 Monitoring the Operation Status of IPv4 over IPv6 Tunnel

This section describes how to monitor an IPv4 over IPv6 tunnel.
Context
In routine maintenance, you can run the following command in any view to check the operation
of IPv4 over IPv6 tunnel.
Procedure
l
l
----End

12.4.2 Debugging IPv4 over IPv6 Tunnel

This section describes how to debug an IPv4 over IPv6 tunnel.
Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
If an operation fault occurs on the IPv4 tunnel, run the following debugging commands in the
user view to debug the IPv4 tunnel. View information about debugging, locate the fault, and
analyze the cause.
For the procedure of displaying the debugging information, refer to the chapter "Information
Center Configuration" in the S9300&S9300E Terabit Routing Switch Configuration Guide -
System Management.
Procedure
Step 1 Run the debugging tunnel { all | control | error | keepalive | packet | timer } [ interface
tunnel interface-number ] command in the user view to debug tunnel information.
----End

12.5 Configuration Examples

This section provides configuration examples of IPv4 over IPv6 tunnel.
Issue 01 (2012-03-15)
Run the display interface tunnel [ interface-number ] command in any view to check the
operation status of the tunnel interface.
Run the display interface tunnel interface-number command in any view to check the
IPv4 attributes of the tunnel interface.
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 IPv4 over IPv6 Tunnel Configuration
228