Huawei S9300 Configuration Manual page 226

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Figure 11-9 Networking diagram for configuring the 6PE
Customer
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data.
l
l
Configuration Procedure
1.
Issue 01 (2012-03-15)
GE 2/0/0
VLANIF 200
4.3.5.1/24
PE 1
GE 1/0/0
VLANIF 100
3000:435::1/64
GE 1/0/0
VLANIF 100
CE 1
3000:435::2/64
IPv6
site
Configure the 6PE to enable the IPv6 capability and configure an IPv4/IPv6 stack.
Configure the 6PE to enable the MPLS capability.
Configure a peer of the 6PE.
Set the IPv6 address and static route for the CE interface.
IP addresses of interfaces
LSR ID
Configure the 6PE to enable the IPv6 capability and configure an IPv4/IPv6 stack.
# Configure PE1 to enable the IPv6 capability.
<Quidway> system-view
[Quidway] sysname PE1
[PE1] ipv6
# Configure PE2 to enable the IPv6 capability.
<Quidway> system-view
[Quidway] sysname PE2
[PE2] ipv6
# Set the IPv6 address for VLANIF 100 of PE1 and the IP address for Loopback0.
[PE1] vlan batch 100 200
[PE1] interface gigabitethernet 1/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE 2/0/0
VLANIF 200
IPv4/MPLS
4.3.5.2/24
3000:1065::1/64
GE 1/0/0
VLANIF 100
3000:1065::2/64
11 IPv6 over IPv4 Tunnel Configuration
PE 2
GE 1/0/0
VLANIF 100
CE 2
IPv6
Customer
site
215