Checking The Configuration; Configuring An Ipv6 Over Ipv4 Tunnel; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
----End

11.3.4 Checking the Configuration

Prerequisites
All configurations are complete.
Procedure
Step 1 Run the display ipv6 interface command to view the IPv6 information about the interface.
----End

11.4 Configuring an IPv6 over IPv4 Tunnel

You can interconnect IPv6 networks by using IPv4 networks.

11.4.1 Establishing the Configuration Task

This section describes the applicable environment, pre-configuration tasks, data preparation, and
configuration procedure for configuring an IPv6 over IPv4 tunnel.
Applicable Environment
To enable communication between two IPv6 networks over the IPv4 network, configure an IPv6
over IPv4 tunnel on the border device of the IPv4 and IPv6 networks.
Pre-configuration Tasks
Before configuring an IPv6 over IPv4 tunnel, complete the following tasks:
l
l
l
Data Preparation
To configure an IPv6 over IPv4 tunnel, you need the following data.
No.
1
2
3
Issue 01 (2012-03-15)
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length
The IPv6 EUI-64 address is configured.
Configuring the physical parameters for the interface and ensuring that the status of the
physical layer of the interface is Up
Configuring the link layer protocol for the interface and ensuring that the status of the link
layer protocol on the interface is Up
Configuring the IPv4/IPv6 dual-protocol stacks
Data
Number, IPv6 address and prefix length of the tunnel
Encapsulation mode of packets over the tunnel
Source IPv4 address or interface number of the tunnel
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
} eui-64
191