Huawei S9300 Configuration Manual page 220

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
[SwitchA] display ipv6 interface tunnel 1/0/1
Tunnel1/0/1 current state : UP
IPv6 protocol current state : UP
IPv6 is enabled, link-local address is FE80::201:101
Global unicast address(es):
Joined group address(es):
MTU is 1500 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# On Switch A, ping the 6to4 address of VLANIF 200 of Switch B. Switch A can receive the
response packet from Switch B.
[SwitchA] ping ipv6 2002:0201:0102:1::1
PING 2002:0201:0102:1::1 : 56
--- 2002:0201:0102:1::1 ping statistics ---
----End
Configuration Files
l
Issue 01 (2012-03-15)
2002:201:101::1, subnet is 2002:201:101::/64
FF02::1:FF01:101
FF02::1:FF00:1
FF02::2
FF02::1
Reply from 2002:201:102:1::1
bytes=56 Sequence=1 hop limit=255
Reply from 2002:201:102:1::1
bytes=56 Sequence=2 hop limit=255
Reply from 2002:201:102:1::1
bytes=56 Sequence=3 hop limit=255
Reply from 2002:201:102:1::1
bytes=56 Sequence=4 hop limit=255
Reply from 2002:201:102:1::1
bytes=56 Sequence=5 hop limit=255
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 4/9/25 ms
Configuration file of Switch A
#
sysname SwitchA
#
ipv6
#
vlan batch 100 200
#
interface Vlanif100
ip address 2.1.1.1 255.0.0.0
#
interface Vlanif200
ipv6 enable
ipv6 address 2002:201:101:1::1/64
#
interface Eth-Trunk1
service type tunnel
#
interface GigabitEthernet1/0/1
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet1/0/2
port hybrid pvid vlan 200
port hybrid untagged vlan 200
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
data bytes, press CTRL_C to break
time = 8 ms
time = 25 ms
time = 4 ms
time = 5 ms
time = 5 ms
209