Configuring Ipv4 And Ipv6 Addresses For The Interface - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The view of the interface to be enabled with the IPv6 capability is displayed.
Step 4 Run:
ipv6 enable
The IPv6 capability is enabled on the interface.
Before performing IPv6 configurations in the interface view, you must enable the IPv6 capability
in the interface view.
By default, the IPv6 capability is disabled on the interface.
----End

11.3.3 Configuring IPv4 and IPv6 Addresses for the Interface

You need to configure IPv4 and IPv6 addresses separately on the IPv4 and IPv6 networks.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The interface view of the IPv4 network is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length }
An IPv4 address is assigned to the interface.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
interface vlanif vlan-id
The interface view of the IPv6 network is displayed.
Step 6 Perform the following configuration as required.
l Run:
l Run:
l Run:
l Run:
Issue 01 (2012-03-15)
ipv6 address auto link-local
The link-local address is set to be automatically generated.
ipv6 address ipv6-address link-local
The link-local address of the interface is configured.
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length
The global unicast address is configured.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
}
190