Huawei S9300 Configuration Manual page 49

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure the super-VLAN and sub-VLAN.
# Configure sub-VLAN 2.
<Quidway> system-view
[Quidway] vlan 2
[Quidway-vlan2] quit
# Enable port isolation on GE 1/0/0 and GE 1/0/1.
[Quidway] port-isolate mode l2
[Quidway] interface gigabitethernet 1/0/0
[Quidway-GigabitEthernet1/0/0] port-isolate enable
[Quidway-GigabitEthernet1/0/0] quit
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port-isolate enable
[Quidway-GigabitEthernet1/0/1] quit
# Add GE 1/0/0 and GE 1/0/1 to sub-VLAN 2.
[Quidway] interface gigabitethernet 1/0/0
[Quidway-GigabitEthernet1/0/0] port link-type access
[Quidway-GigabitEthernet1/0/0] port default vlan 2
[Quidway-GigabitEthernet1/0/0] quit
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type access
[Quidway-GigabitEthernet1/0/1] port default vlan 2
[Quidway-GigabitEthernet1/0/1] quit
# Configure super-VLAN 3 and add sub-VLAN 2 to super-VLAN 3.
[Quidway] vlan 3
[Quidway-vlan3] aggregate-vlan
[Quidway-vlan3] access-vlan 2
[Quidway-vlan3] quit
Step 2 Create and configure VLANIF 3.
# Create VLANIF 3.
[Quidway] interface vlanif 3
# Assign an IP address to VLANIF 3.
[Quidway-Vlanif3] ip address 10.10.10.1 24
Step 3 Enable intra-VLAN proxy ARP on VLANIF 3.
[Quidway-Vlanif3] arp-proxy inner-sub-vlan-proxy enable
[Quidway-Vlanif3] quit
Step 4 Verify the configuration.
Issue 01 (2012-03-15)
Create a VLANIF interface of the super-VLAN and assign an IP address to the VLANIF
interface.
Enable intra-VLAN proxy ARP on the VLANIF interface of the super-VLAN.
VLAN IDs of the super-VLAN and sub-VLAN
GE 1/0/1 and GE 1/0/0 belonging to sub-VLAN 2
IP address and subnet mask of VLANIF 3 of super-VLAN 3 being 10.10.10.1 and
255.255.255.0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 ARP Configuration
38