Example For Configuring A 6To4 Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service

11.7.2 Example for Configuring a 6to4 Tunnel

This section provides a configuration example of 6to4 tunnel.
Networking Requirements
As shown in
backbone network respectively. To enable communication between two 6to4 network hosts, you
need to manually configure an 6to4 tunnel between Switch A and Switch B.
To enable communication between 6to4 networks, configure 6to4 addresses for the hosts on the
6to4 network. A 6to4 address has a 48-bit prefix, which is in the format 2002:IPv4 address. As
shown in
to the IPv4 network is 2.1.1.1. Therefore, the 6to4 address prefix of the 6to4 network where
Switch A is located is 2002:0201:0101::.
Figure 11-7 Networking diagram for configuring a 6to4 tunnel
2002:201:101:1::1/64
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Issue 01 (2012-03-15)
#
interface Tunnel1/0/1
ipv6 enable
ipv6 address 3001::2/64
tunnel-protocol ipv6-ipv4
source Vlanif200
destination 192.168.50.2
#
ip route-static 192.168.50.0 255.255.255.0 192.168.51.1
#
return
Figure 11-7, Switch A and Switch B are connected to a 6to4 network and an IPv4
Figure 11-7, the IPv4 address of the interface through which Switch A is connected
GE 1/0/1
VLANIF 100
2.1.1.1
SwitchA
GE 1/0/2
VLANIF 200
2002:201:101::1/64
2002:201:101:1::2
PC1
IPv6
Enabling the service loopback function on an Eth-Trunk interface.
Configure the IPv4/IPv6 stack on the Switch.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IPv4
Tunnel 1/0/1
2002:201:102::1/64
2002:201:102:1::2
11 IPv6 over IPv4 Tunnel Configuration
GE 1/0/1
VLANIF 100
2.1.1.2
SwitchB
VLANIF 200
2002:201:102:1::1/64
Tunnel 1/0/1
GE 1/0/2
PC2
IPv6
206