Checking The Configuration; Maintaining Udp Helper; Clearing Udp Helper Statistics - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
udp-helper server ip-address
The destination server to which UDP packets are forwarded is configured .
After the UDP Helper function is enabled, if the destination UDP port of the packet received by
the VLANIF interface is the same as the UDP port for packet relay, the packet is forwarded to
the destination server configured on the VLANIF interface.
----End

7.3.5 Checking the Configuration

Prerequisites
The configurations of the UDP helper function are complete.
Procedure
l
----End
Example
Run the display udp-helper server command to check the number of the VLANIF interface
that relays UDP packets, the IP address of the destination server, and the number of forwarded
UDP packets.
<Quidway> display udp-helper server interface Vlanif 100
vlan-interface
Vlanif100

7.4 Maintaining UDP Helper

This section describes how to maintain UDP helper.

7.4.1 Clearing UDP Helper Statistics

Issue 01 (2012-03-15)
Run the display udp-helper server [ interface vlanif vlan-id ] command to check
information about UDP packets forwarded on the interface
Server-Ip
10.10.10.10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 UDP Helper Configuration
packet-num
20
136