Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The system view is displayed.
Step 2 Run:
dhcp server database enable
The S9300&S9300E automatically saves DHCP data to the CF card.
After the dhcp server database enable command is executed, the system generates the
lease.txt and conflict.txt files in the CF card. The two files save the address lease information
and address conflict information.
Step 3 Run:
dhcp server database write-delay interval
The interval for saving DHCP data is set.
By default, DHCP data is not automatically saved to CF card. After the S9300&S9300E is
configured to automatically save DHCP data, the S9300&S9300E saves data every 7200 seconds
by default and the latest data overwrites the previous data.
Step 4 Run:
dhcp server database recover
The DHCP data in the storage device is restored.
After the dhcp server database recover command is executed, the S9300&S9300E restores
the DHCP data in the CF card.
----End

3.4.8 Checking the Configuration

This section describes how to view the configuration of the DHCP server based on the VLANIF
interface address pool.
Prerequisites
The configurations of the DHCP server based on the VLANIF interface address pool are
complete.
Procedure
l
l
----End
Example
Run the display dhcp server statistics command view the statistics about the DHCP server.
The similar information is displayed.
<Quidway> display dhcp server statistics
Server Statistics:
Client Request:
Dhcp Discover:
Issue 01 (2012-03-15)
Run the display dhcp server statistics command to view the statistics about the DHCP
server.
Run the display ip pool interface interface-name [ start-ip-address high-ip-address | all |
expired | conflict | used ] command to view information about the interface address pool.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6
1
3 DHCP Configuration
64