Configuring A Tunnel Interface - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
l
l
Do as follows on the S9300&S9300E.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Step 3 Run:
service type tunnel
The Eth-Trunk interface is enabled with the service loopback function.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
interface interface-type interface-number
The interface view is displayed.
Step 6 Run:
eth-trunk trunk-id
The interface is added to the Eth-Trunk.
----End

12.3.3 Configuring a Tunnel Interface

To configure a tunnel interface, you need to configure the source and destination addresses of
the tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface tunnel interface-number
The tunnel interface is created and the tunnel interface view is displayed.
Step 3 Run:
tunnel-protocol ipv4-ipv6
Issue 01 (2012-03-15)
Before enabling the service loopback function, create an Eth-Trunk, add member interfaces
to the Eth-Trunk and keep it in the Up state.
Only one interface enabled with the service loopback function is needed on a device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 IPv4 over IPv6 Tunnel Configuration
225