Huawei S9300 Configuration Manual page 21

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Configuration Roadmap
The configuration roadmap is as follows:
l
l
l
l
Data Preparation
To complete the configuration, you need the following data.
l
l
l
l
Procedure
Step 1 # Configure Switch A.
# Set an IP address for Loopback0 of Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] interface loopback 0
[SwitchA-LoopBack0] ip address 116.116.116.116 32
[SwitchA-LoopBack0] quit
Configure OSPF.
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 116.116.116.116 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Tunnel 3/0/15 to borrow the IP address of Loopback0.
[SwitchA] interface tunnel 3/0/15
[SwitchA-Tunnel3/0/15] ip address unnumbered interface loopback 0
[SwitchA-Tunnel3/0/15] quit
Step 2 Configure Switch C. The configuration procedure is the same as the configuration procedure of
Switch A.
Step 3 Verify the configuration.
# Ping 9.9.9.9 on Switch A.
[SwitchA] ping 9.9.9.9
PING 9.9.9.9: 56
--- 9.9.9.9 ping statistics ---
Issue 01 (2012-03-15)
Set addresses of the Loopback0 interfaces of Switch A and Switch C.
Configure OSPF.
Configure Tunnel 3/0/15 of Switch A to borrow the IP address of Loopback0.
Configure Tunnel 3/0/15 of Switch C to borrow the IP address of Loopback0.
IP address for Loopback0 of Switch A
IP address for Loopback0 of Switch C
Index for Loopback0 of Switch A
Index for Loopback0 of Switch C
data bytes, press CTRL_C to break
Reply from 9.9.9.9: bytes=56 Sequence=1 ttl=255 time=2 ms
Reply from 9.9.9.9: bytes=56 Sequence=2 ttl=255 time=3 ms
Reply from 9.9.9.9: bytes=56 Sequence=3 ttl=255 time=3 ms
Reply from 9.9.9.9: bytes=56 Sequence=4 ttl=255 time=3 ms
Reply from 9.9.9.9: bytes=56 Sequence=5 ttl=255 time=3 ms
5 packet(s) transmitted
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Addresses Configuration
10