Dhcp Server - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Figure 3-6 Networking diagram for configuring the DHCP server based on the global address
pool
SwtichB
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
Name and range of the global address pool on SwitchA
Procedure
Step 1 Enable DHCP.
<Quidway> system-view
[Quidway] dhcp enable
Step 2 Create address pools and set the attributes of the address pools.
# Set the attributes of IP address pool 1, including the address pool range, DNS address, egress
gateway address, and address lease.
[Quidway] ip pool 1
[Quidway-ip-pool-1] network 10.1.1.0 mask 255.255.255.128
[Quidway-ip-pool-1] dns-list 10.1.1.2
Issue 01 (2012-03-15)
NetBIOS DHCP
server client
GE 1/0/1
VLANIF10
10.1.1.1/25
DNS DHCP
server client
Network: 10.1.1.0/25
Enable the DHCP server function on SwitchA.
Create a global address pool on SwitchA and set the attributes of the address pool, including
the range of the address pool, egress gateway, NetBIOS address, and address lease.
Configure VLANIF interfaces to use the global address pool to allocate IP addresses.
NOTE
The following configurations are performed on SwitchA.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE 1/0/2
VLANIF20
10.1.1.129/25
SwtichA

DHCP server

Network: 10.1.1.128/25
3 DHCP Configuration
DHCP DHCP
client client
SwtichC
DHCP DHCP
client client
73