Configuring Routes In The Tunnel; Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The tunnel is specified as an IPv4 over IPv6 tunnel.
Step 4 Run:
source { source-ip-address | interface-type interface-number }
The source IPv6 address or source interface of the tunnel interface is specified.
Step 5 Run:
destination ip-address
The destination IPv6 address of the Tunnel interface is configured.
Step 6 Run one of the following commands to specify the IP address of the tunnel interface:
l Run the ip address ip-address { mask | mask-length } [ sub ] command to configure the IPv4
l Run the ip address unnumbered interface interface-type interface-number command to
----End

12.3.4 Configuring Routes in the Tunnel

Packets can be normally forwarded only when routes exist on both the source device and
destination device of the tunnel. Do as follows on the devices on both ends of the tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Choose one of the following methods to configure the route with the outgoing interface as the
tunnel interface:
l Run the ip route-static ip-address { mask | mask-length } tunnel interface-number command
l Configure dynamic routes. You can use the Border Gateway Protocol (BGP) or the Interior
----End

12.3.5 Checking the Configuration

You can view the configuration of an IPv4 over IPv6 tunnel.
Prerequisites
The configurations of the IPv4 over IPv6 Tunnel function are complete.
Issue 01 (2012-03-15)
address of the tunnel interface.
configure the tunnel interface to borrow an IPv4 address.
to configure static routes. When configuring the static routes, you must configure the both
ends of the tunnel. Note that the destination address is the destination IPv4 address of the
packet to be encapsulated with the IPv4 over IPv6 tunnel; the next hop is the local tunnel
interface.
Gateway Protocol (IGP), excluding Intermediate System-to-Intermediate System (IS-IS).
Detailed configurations are not mentioned here.
When configuring a dynamic routing protocol, you must enable it on the tunnel interface and
the interface on the link through which the IPv4 network is connected to the IPv6 network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 IPv4 over IPv6 Tunnel Configuration
226