Configuring Local Span Based On Mac Addresses; Checking The Configuration - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
No.
2
3

8.8.2 Configuring Local SPAN Based on MAC Addresses

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
observe-port index interface interface-type interface-number
An observing port is configured.
Step 3 Run:
vlan vlan-id
The VLAN view is displayed.
Step 4 Run:
mac-mirroring mac-address to observe-port index inbound
Local SPAN based on MAC addresses is configured.
You can repeatedly perform
MAC addresses in multiple VLANs.
----End

8.8.3 Checking the Configuration

Run the following commands to check the previous configuration.
Action
Check information about the
observing port.
Check information about port
mirroring.
If the following results are obtained, the configuration is successful:
l
l
Issue 01 (2011-07-15)
Data
MAC address of the packets to be mirrored
ID of the VLAN that the observed MAC address belongs to
The type of the observing port is configured properly.
The number of the observing port is configured properly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 3 and Step 4 to monitor the incoming packets with multiple
Command
display observe-port
display port-mirroring
8 Mirroring
89