Drive Belt; Cvt Cover Drain Plug; Valve Adjustment; Spark Arrester - Can-Am outlander 400 series Operator's Manual

When liquids/deposits are found, the
air filter must be inspected, dried or
replaced depending on its condition.
Remove air filter as explained below.

Drive Belt

See an authorized
distributor/dealer to check the width
and the condition of drive belt.

CVT Cover Drain Plug

Any time you suspect that water has
entered the CVT cover, drain the CVT
housing by removing the drain plug.
LH SIDE
1. Drain plug

Valve Adjustment

See an authorized
distributor/dealer for valves adjust-
ment.
Insufficient clearance will cause loss
of power and possibly damage the
valves. Excessive
cause noise.

Spark Arrester

The muffler must be periodically
purged of accumulated carbon.
Can-Am ATV
Can-Am ATV
clearance will
_____________________
WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust sys-
tem is very hot. Make sure that
there are no combustible materi-
als in the area. Wear eye protec-
tion and gloves. Never stand be-
hind the vehicle while purging ex-
haust system. Respect all applica-
ble laws and regulations.
Select a well-ventilated area and make
sure the muffler is cool.
Place transmission on PARK position.
Remove the clean-out plug of the muf-
fler.
1. Clean-out plug
2. Muffler
Block the end of the muffler with a
shop rag and start engine.
Momentarily increase engine RPM
several times to purge accumulated
carbon out of the muffler.
Stop engine and allow muffler to cool.
Reinstall the cleanout plug.

Radiator

Periodically check the radiator area for
cleanliness.
125