General; Procedures; Magneto Cover - Can-Am DS 450 2008 Shop Manual

GENERAL

WARNING
Always disconnect BLACK (-) cable first and
reconnect last.
The engine removal is not necessary to work on
the magneto system.
During assembly/installation, use the torque val-
ues and service products as in the exploded
views.
Clean threads before applying a threadlocker. Re-
fer to SELF-LOCKING FASTENERS AND LOCTITE
APPLICATION at the beginning of this manual for
complete procedure.
WARNING
Torque wrench tightening
must strictly be adhered to.
Locking devices (ex: locking tabs, elastic stop
nuts, self-locking fasteners, cotter pin, etc.)
must be installed or replaced with new ones
where specified. If the efficiency of a locking
device is impaired, it must be renewed.

PROCEDURES

MAGNETO COVER

Magneto Cover Removal
Remove seat. Refer to
Disconnect stator connector.
vmr2008-025-010_a
RIGHT SIDE VIEW
1. Air inlet silencer
2. Brake fluid reservoir
3. Stator connector
Disconnect CPS connector.
vmr2008-015
specifications
BODY
.
Subsection 06 (MAGNETO/STARTER)
vmr2008-022-019_a
RH SIDE OF VEHICLE
Safely lift RH side to tilt vehicle as much as possi-
ble. This will minimize oil loss.
Remove protection shield screws.
vmr2008-014-002_a
1. Top screw
2. Bottom screws
3. Protection shield
Slide out shield towards bottom as shown.
Section 03 ENGINE
69