Oil Pressure Regulator; Coolant Replacement - Can-Am Rally 200 Operator's Manual

Reinstall oil strainer plug with a new
gasket.
Change gasket on drain plug. Clean
gasket area on engine and drain plug
then reinstall plug. Refill engine at the
proper level with the recommended
oil. Refer to SPECIFICATIONS for ca-
pacity.
Start engine and let idle for a few min-
utes. Ensure oil filter area and drain
plug areas are not leaking.
Stop engine. Wait a while to allow oil
to flow down to crankcase then check
oil level. Refill as necessary.
Dispose of oil as per your local envi-
ronmental regulations.

Oil Pressure Regulator

When changing engine oil at each 50
hours, the oil pressure regulator must
be removed and cleaned.
The oil pressure regulator is located on
the left side of the engine, near the
cooling drain plug.
V06C2FY
1. Cooling drain plug
2. Oil pressure regulator plug
Clean plug area then remove it.
Remove valve housing, compression
spring and ball.
_____________________
104
2 1
4 3
R175motr135Y
1. Valve housing
2. Compression spring
3. Ball
4. Oil pressure valve port
NOTE: Oil coming out will push out
spring loaded ball; take care not to lose
spring and ball.
Clean all parts and oil pressure regula-
tor port.
Check compression spring's free
length. If the length of the spring
is less than 13.2 mm (.519 in), replace
it by a new one.
Install all removed parts and torque the
plug to 30 N•m (22 lbf•ft).

Coolant Replacement

WARNING
In order to avoid potential burns,
do not remove the radiator cap or
loosen the coolant drain plug if the
engine is hot.
Remove front fascia.
Turn the radiator cap counterclockwise
and remove it.
Unscrew the drain plug located on
the left side of engine and drain the
coolant into a suitable container.
2 1