Evaporative Emission System Pre-Filter (If Equipped); Engine Oil - Can-Am MAVERICK Sport MAX Series Operator's Manual

NOTICE
Maintaining a clean CVT
air filter will maximize air flow for an
optimum CVT components lifespan.
Evaporative Emission
System Pre-Filter (If
Equipped)
Evaporative Emission System
Pre-Filter Replacement
1. Remove rear body module, refer
ACCESSING MAINTENANCE
to
COMPONENTS
2. On LH side, remove side panel.
3. Remove the hose clamps.
4. Remove the retaining screws.
5. Remove the pre-filter assembly.
219001880-063_a
1. Pre-Filter
2. Retaining screw
3. Clamps
6. Install a new pre-filter assembly.
TIGHTENING TORQUE
Pre-filter
retaining
screw
7. Secure hoses with clamps.
8. Install rear body module and tighten
all screws to specifications.
.
2.5 N•m ± 0.5 N•m
(22 lbf•in ± 4 lbf•in)
Cargo box
retaining
screw
Upper cage
extension
screw
Lower cage
extension
screw

Engine Oil

Engine Oil Level Verification
NOTICE
with an improper level may severely
damage engine.
NOTICE
gine is cold.
1. Place vehicle on a level surface.
2. Clean around dipstick to avoid for-
eign particles falling down the tube.
3. Unscrew dipstick then remove it
and wipe clean.
219001880-028_a
1. Engine oil dipstick
4. Reinstall dipstick, screw in it com-
pletely.
5. Remove dipstick and check oil level.
It should be near or equal to the up-
per mark.
______________
MAINTENANCE PROCEDURES
TIGHTENING TORQUE
2.5 N•m ± 0.5 N•m
(22 lbf•in ± 4 lbf•in)
24.5 N•m ± 3.5 N•m
(18 lbf•ft ± 3 lbf•ft)
Operating
Check oil level when en-
the engine
103