Engine Oil - Can-Am MAVERICK X3 Series 2017 Operator's Manual

219001761-204_a
1. CVT air filter
Step 1: Unlatch
Step 2: Lift the rear part
Step 3: Pull off
CVT Air Filter Inspection and
Cleaning
Inspect filter and replace if necessary.
Remove CVT filter. Refer to
TER REMOVAL
soap and water then rinse with water.
Gently shake off excess water and al-
low filter to dry at room temperature.
CVT Air Filter Installation
Reinstall filter:
– Insert the three tabs at front of the
filter in the corresponding slots
– Securely latch the filter.
Reinstall the air box cover. Make sure it
is properly secured.

Engine Oil

Engine Oil Level Verification
NOTICE
Operating
with an improper level may severely
damage engine.
With the engine at normal operating
temperature, place vehicle on a level
surface and check the oil level as fol-
lows:
1. Start engine and let it idle for at least
20 seconds.
2. Stop engine.
3. Unscrew dipstick then remove it
and wipe clean.
CVT FIL-
and clean it using soft
the engine
219001761-085_a
LH REAR OF VEHICLE
1. Dipstick
4. Reinstall dipstick, screw it in com-
pletely.
5. Remove dipstick and check oil level.
It should be near or equal to the up-
per mark.
tmo2011-001-076_a
TYPICAL
1. MIN
2. MAX
3. Operating range
To add oil, remove the dipstick. Place a
funnel into the dipstick tube.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark.
NOTE: Do not overfill. Wipe off any
spillage.
Properly tighten dipstick.
_______________
MAINTENANCE PROCEDURES
85