Engine; Oil Change And Oil Filter Replacement - Can-Am 2008 DS 450 Operator's Manual

ENGINE

Among other things, this section gives
the procedures to replace the liquids.
Refer to LIQUIDS for procedures to
check levels and refill.
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.
WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
Oil Drainage
vmo2008-011-040_a
LH SIDE OF VEHICLE
1. Oil filter
vmo2008-011-105_a
1. Oil tank drain plug
2. Engine drain plug
Ensure vehicle is on a level surface.
Remove oil tank cap.
vmo2008-011-014_a
1. Engine oil tank cap
Clean drain plugs area.
Place a drain pan under the oil tank
drain plug area.
Remove drain plug and drain all oil
from oil tank.
Place a drain pan under the engine
drain plug area.
Remove drain plug and drain all oil
from engine.
Wipe out any oil spillage on frame.
NOTE: Allow enough time for oil to
flow out of oil filter.
Oil Tank Strainer Cleaning
NOTE:
CHART for oil tank strainer clean-
ing frequency.
Remove bolts retaining oil tank outlet
fitting.
_____________________
Refer to MAINTENANCE
105