Ip Igmp Snooping Vlan Static - Cisco Catalyst 3650 series Command Reference Manual

ip igmp snooping vlan static

To enable Internet Group Management Protocol (IGMP) snooping and to statically add a Layer 2 port as a
member of a multicast group, use the ip igmp snooping vlan static global configuration command on the
device stack or on a standalone device. Use the no form of this command to remove ports specified as members
of a static multicast group.
ip igmp snooping vlan vlan-id static ip-address interface interface-id
no ip igmp snooping vlan vlan-id static ip-address interface interface-id
Syntax Description
vlan-id
ip-address
interface interface-id
Command Default
By default, there are no ports statically configured as members of a multicast group.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP snooping.
The configuration is saved in NVRAM.
Enables IGMP snooping on the specified VLAN. The range is 1 to 1001 and 1006
to 4094.
Adds a Layer 2 port as a member of a multicast group with the specified group IP
address.
Specifies the interface of the member port. The interface-id value has these options:
• fastethernet interface number—A Fast Ethernet IEEE 802.3 interface.
• gigabitethernet interface number—A Gigabit Ethernet IEEE 802.3z interface.
• tengigabitethernet interface number—A 10-Gigabit Ethernet IEEE 802.3z
interface.
• port-channel interface number—A channel interface. The range is 0 to 128.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
ip igmp snooping vlan static
Modification
This command was introduced.
229