Monitor Session Type Erspan-Source - Cisco Catalyst 3650 series Command Reference Manual

monitor session type erspan-source

monitor session type erspan-source
To configure a local Encapsulated Remote Switched Port Analyzer (ERSPAN) source session, use the monitor
session type erspan-source command in global configuration mode. To remove the ERSPAN configuration,
use the no form of this command.
monitor session span-session-number type erspan-source
no monitor session span-session-number type erspan-source
Syntax Description
span-session-number
Command Default
ERSPAN source session is not configured.
Command Modes
Global configuration (config)
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
The span-session-number and the session type (configured by the erspan-source keyword) cannot be changed
once configured. Use the no form of this command to remove the session and then re-create the session with
a new session ID or a new session type.
The ERSPAN source session destination IP address, which must be configured on an interface on the destination
switch, is the source of traffic that an ERSPAN destination session sends to the destination ports. You can
configure the same address in both the source and destination sessions with the ip address command in
ERSPAN monitor destination session configuration mode.
The ERSPAN ID differentiates the ERSPAN traffic arriving at the same destination IP address from different
ERSPAN source sessions.
The maximum local ERSPAN source session limit is 8.
Examples The following example shows how to configure an ERSPAN source session number:
Switch(config)# monitor session 55 type erspan-source
Switch(config-mon-erspan-src)#
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
514
Number of the local ERSPAN session. Valid values
are from 1 to 66.
Modification
This command was introduced.