Auto Qos Classify - Cisco Catalyst 3650 series Command Reference Manual

auto qos classify

auto qos classify
To automatically configure quality of service (QoS) classification for untrusted devices within a QoS domain,
use the auto qos classify command in interface configuration mode. To return to the default setting, use the
no form of this command.
auto qos classify [police]
no auto qos classify [police]
Syntax Description
police
Command Default
Auto-QoS classify is disabled on the port.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use this command to configure the QoS for trusted interfaces within the QoS domain. The QoS domain
includes the device, the network interior, and edge devices that can classify incoming traffic for QoS.
When auto-QoS is enabled, it uses the ingress packet label to categorize traffic, to assign packet labels, and
to configure the ingress and egress queues.
Table 29: Auto-QoS Configuration for the Egress Queues
Egress Queue
Priority (shaped)
SRR shared
SRR shared
SRR shared
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
602
(Optional) Configure QoS policing for untrusted devices.
Queue Number CoS-to-Queue
Map
1 4, 5
2 2, 3, 6,7
3 0
4 1
Modification
This command was introduced.
Queue Weight Queue (Buffer)
(Bandwidth) Size for
Gigabit-Capable
Ports
up to 100 25 percent
percent
10 percent 25 percent
60 percent 25 percent
20 percent 25 percent
Queue (Buffer)
Size for 10/100
Ethernet Ports
15 percent
25 percent
40 percent
20 percent