Stack-Power - Cisco Catalyst 3650 series Command Reference Manual

stack-power

stack-power
To configure StackPower parameters for the power stack or for a switch in the power stack, use the stack
power command in global configuration mode. To return to the default setting, use the no form of the command,
stack-power {stack power-stack-name| switch stack-member-number}
no stack-power {stack power-stack-name| switch stack-member-number}
Syntax Description
stack power-stack-name
switch stack-member-number
Command Default
There is no default.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
When you enter the stack-power stack power stack name command, you enter power stack configuration
mode, and these commands are available:
• default—Returns a command to its default setting.
• exit—Exits ARP access-list configuration mode.
• mode—Sets the power mode for the power stack. See the mode command.
• no—Negates a command or returns to default settings.
If you enter the stack-power switch switch-number command with a switch number that is not participating
in StackPower, you receive an error message.
When you enter the stack-power switch switch-number command with the number of a switch participating
in StackPower, you enter switch stack power configuration mode, and these commands are available:
• default—Returns a command to its default setting.
• exit—Exits switch stack power configuration mode.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
128
Specifies the name of the power stack. The name can be up to 31 characters.
Entering these keywords followed by a carriage return enters power stack
configuration mode.
Specifies the switch number in the stack (1 to 4) to enter switch stack-power
configuration mode for the switch.
Modification
This command was introduced.