Snmp-Server Enable Traps Bridge - Cisco Catalyst 3650 series Command Reference Manual

snmp-server enable traps bridge

To generate STP bridge MIB traps, use the snmp-server enable traps bridge command in global configuration
mode. Use the no form of this command to return to the default setting.
snmp-server enable traps bridge [newroot] [topologychange]
no snmp-server enable traps bridge [newroot] [topologychange]
Syntax Description
newroot
topologychange
Command Default
The sending of bridge SNMP traps is disabled.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples This example shows how to send bridge new root traps to the NMS:
Device(config)# snmp-server enable traps bridge newroot
(Optional) Enables SNMP STP bridge MIB new root traps.
(Optional) Enables SNMP STP bridge MIB topology change traps.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
snmp-server enable traps bridge
535