Mpls Ip Default-Route - Cisco Catalyst 3650 series Command Reference Manual

mpls ip default-route

mpls ip default-route
To enable the distribution of labels associated with the IP default route, use the mpls ip default-route command
in global configuration mode.
mpls ip default-route
Syntax Description
This command has no arguments or keywords.
Command Default
No distribution of labels for the IP default route.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
Dynamic label switching (that is, distribution of labels based on routing protocols) must be enabled before
you can use the mpls ip default-route command.
Examples
The following example shows how to enable the distribution of labels associated with the IP default route:
Switch# configure terminal
Switch(config)# mpls ip
Switch(config)# mpls ip default-route
Related Commands
Command
mpls ip (global configuration)
mpls ip (interface configuration)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
376
Modification
This command was introduced.
Description
Enables MPLS forwarding of IPv4 packets along
normally routed paths for the platform.
Enables MPLS forwarding of IPv4 packets along
normally routed paths for a particular interface.