Show Switch - Cisco Catalyst 3650 series Command Reference Manual

show switch

To display information that is related to the stack member or the switch stack, use the show switch command
in EXEC mode.
show switch [stack-member-number| detail| neighbors| stack-ports [summary]]
Syntax Description
stack-member-number
detail
neighbors
stack-ports
summary
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
This command displays these states:
• Initializing—A switch has been just added to the stack and it has not completed the basic initialization
• HA Sync in Progress—After the standby is elected, the corresponding switch remains in this state until
• Syncing—A switch that is added to an already existing stack remains in this state until the switch add
• Ready—The member has completed loading the system- and interface-level configurations and can
to go to the ready state.
the synchronization is completed.
sequence is complete.
forward traffic.
(Optional) Number of the stack member. The range is 1 to 9.
(Optional) Displays detailed information about the stack ring.
(Optional) Displays the neighbors of the entire switch stack.
(Optional) Displays port information for the entire switch
stack.
(Optional) Displays the stack cable length, the stack link
status, and the loopback status.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
show switch
871