Show Interfaces Counters - Cisco Catalyst 3650 series Command Reference Manual

show interfaces counters

To display various counters for the switch or for a specific interface, use the show interfaces counters
command in privileged EXEC mode.
show interfaces [interface-id] counters [errors| etherchannel| module stack-member-number| protocol
status| trunk]
Syntax Description
interface-id
errors
etherchannel
module
stack-member-number
protocol status
trunk
Though visible in the command-line help string, the vlan vlan-id keyword is not supported.
Note
Command Default
None
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
If you do not enter any keywords, all counters for all interfaces are included.
(Optional) ID of the physical interface, including type, stack member
(stacking-capable switches only) module, and port number.
(Optional) Displays error counters.
(Optional) Displays EtherChannel counters, including octets, broadcast
packets, multicast packets, and unicast packets received and sent.
(Optional) Displays counters for the specified stack member.
Note In this command, the module keyword refers to the stack member
number. The module number that is part of the interface ID is always
zero.
(Optional) Displays the status of protocols enabled on interfaces.
(Optional) Displays trunk counters.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
show interfaces counters
Modification
This command was introduced.
81