Debug Ilpower - Cisco Catalyst 3650 series Command Reference Manual

debug ilpower

To enable debugging of the power controller and Power over Ethernet (PoE) system, use the debug ilpower
command in privileged EXEC mode. To disable debugging, use the no form of this command.
debug ilpower {cdp| event| ha| ipc| police| port| powerman| registries| scp | sense| upoe}
no debug ilpower {cdp| event| ha| ipc| police| port| powerman| registries| scp | sense| upoe}
Syntax Description
cdp
event
ha
ipc
police
port
powerman
registries
scp
sense
upoe
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
This command is supported only on PoE-capable switches.
Displays PoE Cisco Discovery Protocol (CDP) debug messages.
Displays PoE event debug messages.
Displays PoE high-availability messages.
Displays PoE Inter-Process Communication (IPC) debug messages.
Displays PoE police debug messages.
Displays PoE port manager debug messages.
Displays PoE power management debug messages.
Displays PoE registries debug messages.
Displays PoE SCP debug messages.
Displays PoE sense debug messages.
Displays Cisco UPOE debug messages.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
debug ilpower
Modification
This command was introduced.
29