Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

show interfaces
err-disabled
trunk
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting, precedence,
random-detect, rate-limit, and shape keywords are not supported.
Command Default
None
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
The show interfaces capabilities command with different keywords has these results:
• Use the show interface capabilities module number command to display the capabilities of all interfaces
• Use the show interfaces interface-id capabilities to display the capabilities of the specified interface.
• Use the show interfaces capabilities (with no module number or interface ID) to display the capabilities
Examples This is an example of output from the show interfaces command for an interface on stack member 3:
Device# show interfaces gigabitethernet3/0/2
GigabitEthernet3/0/2 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is 2037.064d.4381 (bia 2037.064d.4381)
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

78
on that switch in the stack. If there is no switch with that module number in the stack, there is no output.
of all interfaces in the stack.
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
(Optional) Displays interfaces in an error-disabled state.
(Optional) Displays interface trunk information. If you do not
specify an interface, only information for active trunking ports
appears.
Modification
This command was introduced.