Ip Igmp Snooping Vlan Static - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Cisco IOS Commands

ip igmp snooping vlan static

Use the ip igmp snooping vlan vlan-id static global configuration command to add a Layer 2 port as a
member of a multicast group. Use the no form of this command to remove the configuration.
Syntax Description
vlan vlan-id
static mac-address
interface interface-id
Defaults None configured.
Command Modes
Global configuration
Command History Release
12.0(5.2)WC(1)
Usage Guidelines
The command is used to statically configure the IP multicast group member ports.
The static ports and groups are saved in nonvolatile RAM (NVRAM).
Static connections to multicast routers are supported only on switch ports.
Examples
This example shows how to statically configure a host on an interface:
Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface fastethernet0/6
Configuring port FastEthernet 0/6 on group 0100.5e02.0203
You can verify your settings by entering the show mac address-table multicast privileged EXEC
command.
78-11381-05
ip igmp snooping vlan vlan-id static mac-address interface interface-id
no ip igmp snooping vlan vlan-id static mac-address interface interface-id
Specify the VLAN ID. The range is 1 to 4094 when the enhanced
software image (EI) is installed and 1 to 1001 when the standard software
image (SI) is installed. Do not enter leading zeros.
Specify the static group MAC address.
Specify the interface configured to a static router port.
Modification
This command was first introduced.
Catalyst 2950 Desktop Switch Command Reference
ip igmp snooping vlan static
2-79